![]() ![]() I n a few instances, you may find a very long random Wi-Fi password (64 bits) on the extender if you use WPS to pair router and extender. Go to Wireless Settings to locate the Wi-Fi password of the extender.Ĭheck out FAQ Method 2 for details: How to use my Range Extender properly if your range extender is configured correctly?Ĭase 3: Very long random Wi-Fi password on extender after WPS process Then launch a web browser and type in the IP of the extender to log in to the extender's web page. Login to the router and check what is the IP address of the extender on the router’s client list (you may need help from router support if you do not how to login to the router). Tap ‘Extended Network’ to check the extender's password and use that password to connect the Wi-Fi of the extender. Open Tether APP and login extender in Tether. Double check RE password on Tether APP or Web UI: ( for RE Signal Led/ Wi-Fi Led ON scenario)Ī) Check RE password on TP-Link Tether APP as follows:ĭownload the TP-Link Tether app, connect your mobile device to the home Wi-Fi network. Install the latest firmware update for range extender: How to upgrade the firmware of my range extender (new logo)?ģ. How to configure my range extender via web GUIĢ. How to configure Range Extender via Tether APP RESET: With the extender powered on, use a pin to press the RESET button until all the LED flash once. Factory reset extender and set it up through Web page or Tether APP: RE will get an IP address from the router and in the router’s local network.ġ. RE LED ON indicates that the extender has connected to the router successfully. ![]() If Signal LED/Wi-Fi LED is still off, refer to What should I do if I fail to configure TP-Link Range Extender?Ĭase 2 : RE Signal Led/ Wi-Fi Led is ON, and wireless clients won’t accept the router password Factory reset RE and install it from the beginning, put in the correct Wi-Fi password during setup.Ģ. If the Wi-Fi extender says incorrect password, then the password given to the extender may be incorrect.ġ. RE LED OFF indicates that the extender has not connected to the router yet. When connecting to the Wi-Fi of extender, you should put in the router’s Wi-Fi password.Ĭase 1 : RE Signal Led/ 2.4G or 5G Wi-Fi Led are OFF, and wireless clients won’t accept the router password. ![]() Note: TP-Link range extender will use the same Wi-Fi password as the router after being configured successfully. PS4 / IOS devices fail to connect to RE's Wi-Fi network or failed to get an IP address Very long random password on RE after WPS Ĭertain devices are unable to connect to Wi-Fi extender.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |